After plugging the bleed hole in the replacement bleeder screw I tried it out on the car. I stuck the new screw in and put the syringe on it. I pulled a vacuum with it and took about a half ounce or fluid through the lines. It works very well. To use it with a pump designed for vacuum bleeding brakes you just need to plug the bleed hole and drill through the screw. Then hook it up just as you would if you were using the original screw except don't leave it loose.
5 inches of white misery again today. And it's supposed to get cold, back into the teens for a high.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment