Installed and tested.

The temp got into the low 30's and the wind wasn't too strong so I parked the truck on the side of the garage and started to install the Bak Flip. The rails wouldn't fit without trimming the bed liner in three locations on each side. The clamps went on without a problem but when I went to put the hold down star wheels in they were the wrong ones. A little hack saw work and the problem was over come. When I went to close the lid with the tail gate up the lid wouldn't latch with the tail gate protector on. I removed the 8 screws and took it off and set it aside. I was done in two hours including the clean up of the boxes and foam padding. I made a test run with a plane up to the field and got in two flights. No problems.